Land Rover 110 Tubular Side Step Running Boards. Fire and Ice Style, Limited Edition Black.

Land Rover 110 Tubular Side Step Running Boards. Fire and Ice Style, Limited Edition Black.

Enhances the look of your Defender whilst adding protection and assisting entry and exit.

Features 

• Package includes a pair of smart and robust side steps with all the brackets, bolts and fixings required to install on your Land Rover Defender 110.
• Very easy to fit, clean and maintain. No drilling required. The brackets install conveniently to existing bolt holes in your vehicle’s chassis.
• Suitable for all Defenders on coil spring suspension from 2003 onwards (not 2 door pickup).
• Helps protect your Defender from damage caused by mud and rocks as well as debris thrown up from the wheels.
• A sturdy wide platform allowing easy ingress and exit to the cab and a step to reach to the roof/roof rack for loading and unloading equipment and cleaning.
• Made with heavy-duty SUS201 black powder-coated stainless steel. 
• Limited Black Edition. 

Important Information

• Some vehicles may have plastic undertray shields covering the side step bolt holes. These will need to be removed before fitting the steps and before re-fitting will need to be trimmed around the bolt locations using a diameter cutter or something similar. If you have any questions, please contact us.
• Please DO NOT use car cleaning products which contain TFR (Traffic Film Remover) chemicals on metallic products as it can cause corrosion.
• We strongly advise examining any bolts, brackets or fixings 7 days after original installation to ensure that they are tight and secure. For your safety, we recommend inspecting all fixtures every 3-6 months.

Industry-leading lifetime warranty on mechanical components & 3yrs warranty on electrical.
VAT invoice provided with every sale.

DEFENDER 110 FITTING GUIDE

• Offer the step into place on the inner edge of floor rails, the front hole is clear, the last rear hole in the rail needs the factory nut and bolt removing.

• If your Defender has a fuel tank on the driver's side then the front fixing bolt is hard to locate The hole is factory drilled on all vehicles.

• The bolt should be pushed through from up behind the tank.

•  Fit the long support brace and clamp (see left-hand photo below) to the edge of the tapered front chassis flange just below the big rubber bush.

• Tighten only enough for the clamp to hold itself in position.

• The short brace fits the 17mm triangular axle support bush bolt.

• Connect up the braces to the tube lugs, but do not tighten at this stage!

• Check alignment of step, then tighten all nuts and bolts and clamp.

• Repeat for the other side, and test.

• The steps are constructed of mild steel and powder coated to protect against rust, to ensure further protection paint tubes with smooth Hammarite or similar.

• These steps are designed for ALL models of Defender with coil springs.

• Check all fixings are secure after 7 days and on a regular basis (every 3-6 months) afterwards.