Description

CETOP3/NG6 Hydraulic Directional Control Kit
High flow directional control for hydraulic winches.

Solenoid Operated Directional Hydraulic Control Valve 24v
Used to start, stop and direct the oil flow.

• Double 24v Coils.
• High Flow up to 80l/min.
• Removable DIN plug connector with clear cover, cable gland and LED indicator.
• Configuration; Spring-centred P open to Tank, A & B Blocked.
• Max Pressure P, A, B, 31.5 MPa (315 bar/4500 psi).
• Manual override feature.

Modular Hydraulic Pressure Regulator Relief Valve
A modular relief valve is used to regulate the maximum pressure within the operating parameters of the winch or other item being controlled.

• Easy to operate rotary calibration control with lock ring.
• Maximum flow 35l/min
• P to T on operation.
• Pressure Adjustment Range 3.5-14 MPa (35-140 bar setting range).
• Supplied with extended bolts for attachment between direction valve and manifold block.

Manifold SubplateForged Steel Construction

• Side Ported P,T,A,B.
• Port size 3/8 inch BSP

Winch Wireless Remote Control, 24V
Converts a 24V solenoid valve on a hydraulic winch from manual switching to the long-range wireless remote control.

• Supplied with two large grip handheld controllers.
• Operating Range over 30m (100ft)
• 250mm output cables to connect to the coils on an existing solenoid control valve.

Industry-leading lifetime warranty on mechanical components & 3yrs warranty on electrical.
VAT invoice provided with every sale.

Instructions:

• Thank you for buying a WINCHMAX wireless remote kit. This should provide many years of trouble-free operation, however, it is essential that it is correctly installed otherwise irreparable damage to the microcircuitry will be caused.
• The basic principle of operation is that once connected to a power supply, the two output wires of the receiver will go to the supply voltage (12v or 24v depending on the model) when the corresponding button on the transmitter (handset) is pressed.
• The output can then be used to operate the trigger terminals on a secondary contactor (solenoid) to switch the main load (e.g. a Winch)
• The outputs MUST NEVER be connected to earth as otherwise they will short circuit and burn out.
• If you have any doubt about which are the trigger terminals on your solenoid, first check by using a thin piece of wire connected to the positive supply, when you apply it to one of the solenoid trigger terminals the winch should run in one direction, if you apply it to the trigger terminal it should operate in the opposite direction.
• In most cases, winches are fitted with a plug-in wander lead, at the back of the wander lead socket you will see three wires. One of the wires is the positive feed to the wander lead switch, depending on which way the switch is pressed this feed will then be diverted down one of the other two wires (the output wires) which will, in turn, be connected to the trigger terminal of the solenoid.
• There are many different types of control configurations, but if you understand the basic principle of operation this should allow you to apply it to whichever set you have. We have provided a schematic of the most common single solenoid pack winch control system (in our diagram trigger terminals on the solenoid are labelled as 1 & 3) but if you have any doubt as to how you should connect your remote DO NOT do it before consulting our office hours helpline for advice.

Diagram for 2 wire motor

Diagram for 4 wire motor